Panda (141) Factory Service Manual (1986-2003): 21 Gearbox and differential

Also for this vehicle: Panda Factory Service Manual (2003-2012).

Choose Sections to see everything in a chapter, or a chapter title to start at its first page.

1. 0100 Introduction and technical data00 Introduction and technical data: Sections
2. 0210 Engine10 Engine: Sections
3. 0321 Gearbox and differential21 Gearbox and differential: Sections
   • Removing-refitting5 pages

     • Panda 750 - 1000
     • Order of operations234
   • Dismantling at the bench5 pages

     • Order of operations
     • Dismantling at the bench2
     • Dismantling at the bench
     • Removing thrust bearing carrier bearings and sleeve
   • Gearbox components5 pages

     • Gearbox casing and components
     • Lay shaft
     • Synchronizers
     • Checking components of the 1st - 2nd speed synchronizer unit
     • Lay shaft assembly
   • Differential unit4 pages

     • Removing roller bearings from differential casing
     • Determining and checking clearance between planet and satellite gears2
     • Gearbox and differential
   • Fitting7 pages

     • Fitting
     • Fitting
     • Fitting2
     • Determining thickness «S» of differential casing bearing pre-loading adjustment shim2
     • Variants for 4 speed gearbox
   • Removing-refitting (Panda 4x4) › Removing-refitting
   • Dismantling at the bench (Panda 4x4)2 pages

     • Cross section of differential unit and reduction gear
     • Dismantling at the bench
   • Differential unit and reduction gear (Panda 4x4)9 pages

     • Fitting differential
     • Removing bevel pinion
     • Determining thickness of adjustment shim
     • Differential unit and reduction gear
     • Fitting and adjusting differential unit
     • Differential unit and reduction gear
     • Determining thickness of «S2» shims for adjusting differential casing bearing pre-loading
     • Gearbox and differential
     • Final positioning of unit
   • Rear transmission clutch (Panda 4x4)3 pages

     • Removing-refitting2
     • Gearbox and differential
   • Drive shafts2 pages

     • Removing and refitting three-lobe joint
     • Gearbox and differential
   • External gearbox controls5 pages

     • External gearbox controls
     • External gearbox controls
     • Gearbox control
     • Gearbox control device assembly
     • Checking gear engagement relay mounting
   • Special tools › Gearbox and differential
   • Tightening torques2 pages

     • Tightening torques
     • Tightening torques
4. 0433 Braking system33 Braking system: Sections
5. 0541 Steering41 Steering: Sections
6. 0644 Suspension and wheels44 Suspension and wheels: Sections
7. 0727 Axle and rear differential (4x4)27 Axle and rear differential (4x4): Sections
8. 0824 Propeller shaft (4x4)24 Propeller shaft (4x4): Sections
9. 0955 Electrical system55 Electrical system: Sections
10. 1070 Bodywork70 Bodywork: Sections