Workshop Manuals Factory service & repair Fiat
01 00 Introduction and technical data02 10 Engine03 21 Gearbox and differential04 33 Braking system05 41 Steering06 44 Suspension and wheels07 27 Axle and rear differential (4x4)08 24 Propeller shaft (4x4)09 55 Electrical system10 70 Bodywork
Fiat Panda (141) Factory Service Manual (1986-2003)04 · 33 Braking system
04 · General

Brake drums

Make
Fiat
Model
Panda (141) Factory Service Manual
Year
1986–2003
Section
Rear brakes › Brake drums
33 Braking systemBrake drums
A hand using a measuring tool to check the inside diameter of a rear brake drum mounted on a hub assembly.

BRAKE DRUMS

Checking and measuring brake drums

If there are deep grooves or uneven wear in the brake drums, it is necessary to reface them. The maximum allowable diameter oversize for brake drums is 0.8 mm.

Two curved brake shoes with friction material lining, lying on a flat surface.

BRAKE SHOES

Checking brake shoes and self-adjusting device

The minimum allowable thickness for brake shoes is 1.5 mm.

A hand using a screwdriver to adjust a component on the back of a rear brake assembly, with a bleed nipple visible.

BLEEDING

Bleeding rear brakes

It is not advisable to reuse the fluid collected. The reservoir should be topped up with new brake fluid.

Parts & tools for this job For 1986 Fiat Panda

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.