Workshop Manuals Factory service & repair Fiat
Fiat Punto (176) Factory Service Manual (1993-1999)02 · 10 Engine
02 · Engine

Removing-refitting power unit

Make
Fiat
Model
Punto (176) Factory Service Manual
Year
1993–1999
Section
Removing-refitting (1372 T) › Removing-refitting power unit
10 EngineRemoving-refitting power unit

REMOVING-REFITTING POWER UNIT

View of the battery and surrounding components in the engine bay
View of the air cleaner assembly and intake manifold area
Close-up view of the accelerator cable connection point
Full view of the engine bay showing the power unit installation
Remove the bonnet lid, position vehicle on lift, drain coolant from engine and fluid from power steering system, then proceed as follows.
  1. Disconnect leads, unscrew retaining screw and remove battery.
  2. Undo the clips, unscrew the screws and remove the air cleaner.
  3. Loosen the bolts and remove the accelerator cable.
  4. Unscrew the bolts and remove the battery mount.
  5. Disconnect the connector, loosen the clip and remove the injector fan.
  6. Disconnect the clutch cable and the earth lead.
View of the battery mounting bracket and associated bolts
Close-up of the injector fan and electrical connector area
View of the clutch cable and earth lead connection points

Parts & tools for this job For 1993 Fiat Punto

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.