Workshop Manuals Factory service & repair Fiat
Fiat Punto (176) Factory Service Manual (1993-1999)02 · 10 Engine
02 · Engine

Removing-refitting

Make
Fiat
Model
Punto (176) Factory Service Manual
Year
1993–1999
Section
Removing-refitting (1372 T) › Removing-refitting
10 EngineRemoving-refitting · page 1 of 10

Removing-refitting

Close-up of engine components with arrows indicating connection points, caption P3M04CJ01
Close-up of engine components with arrows pointing to specific fittings, caption P3M04CJ02
Close-up of engine components with arrows indicating connectors, caption P3M04CJ03
Wide view of the engine bay showing the engine and surrounding components, caption P3M04CJ04
  1. Disconnect the injection timing and rpm/TDC sensor connectors.
  2. Disconnect the connectors of the coolant temperature sender unit, idle adjustment actuator and knock sensor.
  3. Disconnect the coolant temperature sensor connectors from the thermostat and flow meter.
  4. Disconnect the injector cooling switch connector and intake air temperature sensor.
  5. Unscrew the wiring cover retaining screws and disconnect the throttle valve position sensor connector.
  6. Disconnect the alternator cooling duct, petrol vapour pipe, connector and earth leads indicated.
Close-up of engine components with arrows pointing to a pipe connection, caption P3M04CJ05
Close-up of an engine component with two arrows pointing downwards on either side, caption P3M04CJ06
Close-up of engine components with arrows indicating various connections, caption P3M04CJ07

Parts & tools for this job For 1993 Fiat Punto

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.