Roller/pre-tensioner assembly

• place the internal bracket in position in the pillar, inserting the retaining pin, shown in the upper inset;

0,35 daNm

• working from the outside of the pillar, match the outer bracket with the inner one, so that the centering pin (3) engages correctly in the appropriate hole (4) (see illustration on previous page);
• tighten the outer bracket fixing bolts to the recommended torque (lower inset);

Do not use percussion tools.

The rod should ALWAYS ONLY be refitted WITH THE ROLLER/PRE-TENSIONER ASSEMBLY FITTED ON THE VEHICLE, in order to prevent personal injury.

6 daNm

• tighten the bolt fixing the roller/pre-tensioner assembly to the pillar to the recommended torque;

Do not use percussion tools.

• restore the original seal conditions for the roller/pre-tensioner assembly by painting the areas concerned, as appropriate, ensuring that the device is intact and correctly fitted;
• complete the refitting, by reversing the order of the operations carried out for the removal.

Roller/pre-tensioner assembly

1. Roller/pre-tensioner
2. Centre pillar
3. Opening for assembly fixing bolt
4. Assembly fixing bolt
5. Internal bracket
6. Bolts fixing external bracket
7. Internal bracket retaining pin
8. External bracket