Removing-refitting windscreen pillar seal (page 2 of 2)

- using disposable tape, delimit the exact glueing area which should be treated as described below;

- apply black BETAPRIMER 5402 on the entire glueing surface of the seal and wait 10 minutes for it to dry;

NOTE For aesthetic reasons, avoid the emergence of Betaprimer from the glueing perimeter.

- using an appropriate buffer, apply "Type 3MY4297" adhesion promoter; It is advisable to use a mask to avoid inhalations, since the product used is solvent based.

- heat up the area in question to a temperature of 30°C for three minutes using a variable-intensity lamp or a blower (top picture); - heat up the top of the part to a temperature of 30°-40°C for about five minutes (bottom picture);