Refitting

(Cont. Op. 1068A30)

• Disconnect the accelerator control cable from the throttle case bracket.
• Remove the accelerator control cable end from the throttle case.
• Remove the accelerator control cable end from the accelerator pedal.
• Withdraw the rubber accelerator control cable sheath from the engine compartment bulkhead.
• Remove the accelerator control cable from the engine compartment.

Refitting

• Install the accelerator control cable in the engine compartment.
• Fit the rubber accelerator control cable sheath in the engine compartment bulkhead.
• Fit the accelerator control cable end on the throttle case.
• Connect the accelerator control cable on the bracket on the throttle case.
• Tighten the accelerator control cable adjustment lock nuts.
• Complete with Op. 1068A10 ACCELERATOR CONTROL PEDAL - Check, adjust where required and lubricate.
• Complete with Op. 1048A10 COMPLETE AIR CLEANER - R+R.
• Connect the battery (-) terminal.

• Close the engine compartment.