Refitting

(Op. 1028H10 continued)

• Follow Op. 1016A22 TAPPET COVER with supply duct - R+R and Replace gasket.
• Follow Op. 1016C10 SINGLE CYLINDER HEAD- R+R and Replace gasket.
• Follow Op. 1020A10 CRANKCASE OIL SUMP - R+R and Replace gasket.
• Follow Op. 1028H14 SET OF CONNECTING RODS WITH PISTONS - R+R. with engine and cylinder head removed.

Refitting

• Complete with Op. 1028H14 SET OF CONNECTING RODS WITH PISTONS - R+R. with engine and cylinder head removed.
• Complete with Op. 1020A10 CRANKCASE OIL SUMP - R+R and Replace gasket.
• Complete with Op. 1016C10 SINGLE CYLINDER HEAD - R+R and Replace gasket.
• Complete with Op. 1016A22 TAPPET COVER with supply duct - R+R and Replace gasket.
• Complete with Op. 1068A10 ACCELERATOR PEDAL CONTROL - Check, adjustment if necessary and lubrication.
• Connect the negative (-) battery terminal

• Remove the body protection cover.
• Close the engine compartment.
• Remove the vehicle from the hoist.

1028H20 - CONNECTING ROD WITH PISTON - R+R

• See Op. 1028H10 SET OF CONNECTING RODS WITH PISTONS - R+R

1028H24 - CONNECTING ROD WITH PISTON - R+R FOR EACH EXTRA CONNECTING ROD WITH PISTON

• See Op. 1028H20 CONNECTING ROD WITH PISTON - R+R