Installation

[1108] Euro 3

• See Op. 4450B10 Front or rear wheel (one) - r+r
• See Op. 7055B42 Supplementary wheel arch (one) - r+r
• Remove the pipes from the clip on the wheelarch.
• Withdraw the pipes, and take them out of the engine compartment.

1. Undo the fixing nuts (1a) and remove the active charcoal filter (1b).

Installation

[1108] Euro 3

• Fit the inlet and outlet pipes of the active charcoal filter through the wheelarch into the engine compartment.
• Fit the active charcoal filter, securing it with the nuts.
• See Op. 7055B42 Supplementary wheel arch (one) - r+r
• See Op. 4450B10 Front or rear wheel (one) - r+r
• Connect the vapour inlet pipe to the active charcoal filter to the rigid pipe.
• Connect the vapour inlet pipe to the solenoid.
• See Op. 1048A10 Air cleaner filtering element - replace
• Connect the negative (-) battery terminal.

• Close the bonnet lid.
• Remove the car from the ramp.

[1108]

1080E28 - ENABLEMENT SOLENOID FOR FLOW OF FUEL VAPOUR TO INLET - R+R

Removal

[1108] Euro 3

• Open the bonnet.
• Disconnect the battery negative (-) terminal.

• See Op. 1048A10 Air cleaner filtering element - replace

1. Disconnect the electrical connection of the fuel vapour enablement solenoid.

2. Disconnect the vapour inlet pipe to the solenoid from the solenoid.
3. Withdraw the retaining clip upwards.
4. Remove the solenoid from the inlet manifold.

Installation

[1108] Euro 3

• Fit the solenoid in its seating.
• Fit the retaining clip and press it until it clicks in place.
• Connect the electrical connection for the fuel vapour enablement solenoid.

• Connect the vapour inlet pipe to the solenoid.
• See Op. 1048A10 Air cleaner filtering element - replace
• Connect the negative (-) battery terminal.

• Close the bonnet lid.