ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 9293 > < Initial Inspection and Diagnostic Overview|Page 9291
Page 28
background image

YES

SERVICE open in circuit 53 (BK/LB).  RESTORE vehicle.  RETEST system.

NO

SERVICE open in circuit 57 (BK).  RESTORE vehicle.  RETEST system.

AG - One Or More MAP Lamps Inoperative

Pinpoint Test AG: One Or More Map Lamps Inoperative

AG1 - Check Lighting Operation

-

Open and close hood, luggage compartment door and glove compartment door.

-

Observe operation of lamps.

Do other lamps light?

YES

GO to AG2.

NO

Go to Pinpoint Test AK.  See: Pinpoint Tests/Courtesy Lamps/AK - All Demand Lighting Inoperative

AG2 - Check Bulb

-

Remove bulb.

-

Using an ohmmeter, check continuity of bulb.

Is bulb in good condition?

YES

GO to AG3.

NO

REPLACE bulb.  RETEST system.

AG3 - Check Ground

-

Disconnect wiring.

-

Using a volt-ohmmeter, measure resistance between ground and circuit 57 (BK) wire.

Is resistance less than 5 ohms?

YES

SERVICE open in circuit 53 (BK/LB).  RESTORE vehicle.  RETEST system.

NO

SERVICE open in circuit 57 (BK).  RESTORE vehicle.  RETEST system.

AH - Rear Courtesy Lamps Inoperative

Pinpoint Test AH: Rear Courtesy Lamps Inoperative

AH1 - Check Lighting Operation

-

Open and close doors and operate the lamp switch.

-

Observe operation of all other courtesy lamps.

Do other lamps light?

YES

GO to AH2.

NO

GO to Pinpoint Test AB.  See: Pinpoint Tests/Courtesy Lamps/AB - Courtesy Lamps Inoperative

AH2 - Check Bulb

-

Remove lens cover and remove bulb.

-

Using an ohmmeter, check continuity of bulb.

Is bulb in good condition.

YES

Go to AH3.

NO

REPLACE bulb.  RETEST system.

AH3 - Ground Check

-

Remove lamp housing.

-

Disconnect wiring.

-

Using an ohmmeter, measure resistance between ground and circuit57 (BK) wire.

Is resistance less than 5 ohms?

Initial Inspection and Diagnostic Overview|Page 9293 > < Initial Inspection and Diagnostic Overview|Page 9291