Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
2. Pull the axle shafts outward.
CAUTION: Do not damage the rubber O-rings in the U-washer grooves.
4. Install the differential pinion shaft.
1. Align the hole in the differential pinion shaft with the case lock bolt hole.
2. Install a new lock bolt.
NOTE: If a new pinion shaft lock bolt is unavailable coat the threads with Thread lock and Sealer EOAZ-19554-FF or equivalent meeting
Ford specifications WSK-M2G315-A5 and ESE-M4G204-A2 prior to installation.
5. Install the rear brake drums.
6. Install the axle housing cover and fill the rear axle housing with 2.4 liters (5.5 pints) of Motorcraft Synthetic Rear Axle Lubricant F1TZ-19580-B
or equivalent meeting Ford specification WSL-M2C192-A
7. Clean the wheel hub and mounting surfaces.
WARNING: ALWAYS REMOVE ANY CORROSION, DIRT OR FOREIGN MATERIAL ON THE MOUNTING SURFACES OF
THE WHEEL OR THE SURFACE OF THE WHEEL HUB OR BRAKE DRUM THAT CONTACTS THE WHEEL. INSTALLING
WHEELS WITHOUT PROPER METAL-TO-METAL CONTACT AT THE WHEEL MOUNTING SURFACES CAN CAUSE THE
LUG NUT TO LOOSEN AND THE WHEEL TO COME OFF WHILE THE VEHICLE IS IN MOTION, CAUSING LOSS OF
CONTROL.
8. Install the tire and wheel assembly.
1. Position the tire and wheel assembly.
2. Install the lug nuts and lower the vehicle.
3. Tighten the lug nuts.
4. Install the center cap.
9. Lower the vehicle.
