ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Crankshaft Rear Seal > < Intake Manifold

Fiesta 1996 (08.1995-02.2002)

Engine - 1.3L Endura-E (HCS) - Crankshaft Front Seal Fiesta 1996 (08/1995-02/2002)
In-vehicle Repair

Special Tool(s)

Installer, timing cover oil seal

303-091 (21-046)

Remover, crankshaft oil seal

303-293 (21-143)
Materials
Name
Specification
Engine oil
WSS-M2C912-A1 
Cable ties
 

Removal

  1. Disconnect the battery ground cable. For additional information, refer to Section  414-01 Battery, Mounting and Cables.

  1. Remove the upper drive belt cover.

  1. Remove the drive belt.
    • Release the tensioning pulley and remove the drive belt.
  1. Raise the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.

  1. Remove the lower drive belt cover.

  1. Unclip the coolant hose from the bracket.

  1. NOTE:
    NOTE:Lock the crankshaft.
    Remove the crankshaft pulley.

  1. Remove the oil seal using the special tool.

Installation
  1. CAUTION:
    CAUTION:Apply a drop of engine oil to the outer rubber of the oil seal to prevent it from being skewed when it is pressed in. It is essential to avoid getting engine oil on the sealing lip.
    Install a new oil seal.
    1. Slide the special tool onto the hub of the crankshaft pulley.
    1. Place the oil seal on the hub of the crankshaft pulley.
    • Apply a drop of engine oil to the outer rubber of the oil seal.
    1. Put the crankshaft pulley in position and press the seal home by tightening the bolt.

  1. Remove the crankshaft pulley.
    • Take out Special Tool 303-091.

  1. Install the crankshaft pulley.

  1. NOTE:
    NOTE:Locate the drive belt in position.
    Clip the coolant hose into the bracket.

  1. Install the lower drive belt cover.
  1. Lower the vehicle.

  1. NOTE:
    NOTE:Make sure the drive belt is seated correctly.
    Install the drive belt.
    • Slacken the tensioning pulley and locate the drive belt in position.

  1. Install the upper drive belt cover.
  1. Connect the battery ground cable. For additional information, refer to Section  414-01 Battery, Mounting and Cables.

Crankshaft Rear Seal > < Intake Manifold