ford Workshop Repair Guides

Ford Fiesta Workshop Service and Auto Repair Manuals

ABOUT US
Water Pump - 1.8L Endura-DI (Lynx) Diesel > < Thermostat - 1.8L Endura-DI (Lynx) Diesel

Fiesta 1996 (081995-022002) - 18L Endura-DI Diesel Thermostat Housing Replacement

Engine Cooling - Thermostat Housing—1.8L Endura-DI (Lynx) Diesel Fiesta 1996 (08/1995-02/2002)
Removal and Installation

Special Tool(s)

Remover/Installer, Cooling Hose Clamp

303–397 (24–003)

Removal

  1. Drain the cooling system.
    For additional information, refer to Cooling System Draining, Filling and Bleeding in this section.

  1. Using the special tool, disconnect the coolant hose.

  1. Disconnect the glow plug wire electrical connector.

  1. Detach the oil level indicator tube.

  1. Disconnect the coolant hose.

  1. Disconnect the coolant hose.

  1. Remove the thermostat housing.

  1. Remove and discard the gasket.

Installation
  1. NOTE:
    NOTE:Install a new gasket.
    To install, reverse the removal procedure.

Water Pump - 1.8L Endura-DI (Lynx) Diesel > < Thermostat - 1.8L Endura-DI (Lynx) Diesel