Ford Workshop Service and Repair Manuals

Flange Holding Wrench, Universal

205-072 (15-030A)

Remover, Oil Seal

303-112 (21-051)

Installer, Oil Seal

303-656A (21-233A)

1. Remove the accessory drive belt. For additional information, refer to Section  303-05 Accessory Drive.

2. Using the special tool, remove the crankshaft pulley.

3. Using the special tool, remove the crankshaft front oil seal.
   • Discard the oil seal.

1. 

   NOTE:The pulley, installation sleeve, housing and the sealing lip must be free of oil.
   

   NOTE:Install a new crankshaft front oil seal.
   

   NOTE:A new crankshaft front oil seal is supplied preassembled on an installation sleeve.
   Install the crankshaft front oil seal.
   1. Install the installation sleeve and seal assembly onto the crankshaft pulley.
   2. Install the crankshaft front oil seal onto the crankshaft pulley.
   • Remove the installation sleeve.

2. 

   CAUTION:To prevent damage to the oil seal, do not pull the crankshaft pulley out more than 3 mm during seal installation.
   Using the special tool, install the crankshaft pulley.

3. Remove the special tool.

4. Using the special tool, tighten the crankshaft pulley bolt.

5. Install the accessory drive belt. For additional information, refer to Section  303-05 Accessory Drive.