Removal and Installation Special Tool(s) | Locking Tool, Flywheel 303-393 (21-168) | | -
Remove the transaxle clutch housing dust shield. - Remove the dust shield retaining clip.
| | -
Using the starter motor retaining bolts and suitable nuts. Install the special tool. | 5. Remove the components in the order indicated in the following illustration(s) and table(s). 3 - CKP sensor electrical connector 4 - Engine timing belt lower cover retaining bolts 5 - CKP sensor retaining bolt 6. To install, reverse the removal procedure. Removal Details Item 6 : CKP sensor | -
To remove the CKP sensor. - Move the engine timing belt lower cover away from the engine block.
- Remove the CKP sensor from its locating dowel hole.
| Installation Details Item 1 : Crankshaft pulley retaining bolt | -
Install a new crankshaft pulley retaining bolt. | | -
Tighten the crankshaft retaining bolt in two stages. | |