Disassembly and Assembly of Subassemblies Special Tool(s) | Installer, Outer Bearing and Oil Seal 204-016 | | Installer, Extension Housing Bushing/Oil Seal 308-046 | | -
Clamp the input shaft in a clamp. | 2. Disassemble the components in the order indicated in the following illustration(s) and table(s). 3. To assemble, reverse the disassembly procedure. Disassembly Details Item 1 : Retaining bolt - input shaft | -
Remove the input shaft retaining bolt. - Heat the input shaft retaining bolt to approx. 90°C using a hot air gun.
| Item 2 : Input shaft ball bearing with retainer | -
Use the special tool to press off the input shaft ball bearing with its retainer and discard it. | Item 3 : Input shaft parallel roller bearing inner race | -
Press off the inner race of the input shaft parallel roller bearing and discard it. | Assembly Details Item 3 : Input shaft parallel roller bearing inner race | -
NOTE:Install a new input shaft parallel roller bearing inner race. Using the special tool, press on the input shaft parallel roller bearing inner race. | Item 2 : Input shaft ball bearing with retainer | -
NOTE:Install a new input shaft ball bearing with bearing retainer. Press on the input shaft ball bearing with bearing retainer. | Item 1 : Retaining bolt - input shaft | -
NOTE:Install a new input shaft retaining bolt. NOTE:The thread in the input shaft must be clean and free of oil or grease. Screw in the input shaft retaining bolt. | |