Removal and Installation Removal | -
Remove the upper battery cover. | | -
Remove the front bumper cover. For additional information, refer to Section 501-19 Bumpers. | | -
Disconnect the washer pump electrical connectors. - Unclip the wiring harness.
- Disconnect the washer hoses from the washer pump.
| | -
Remove the front fender bolts on both sides. | | -
Fabricate two M10 x 250 mm guide bars out of a suitable threaded bar. | | -
Loosen the lock panel. - Remove the front bumper bracket upper retaining bolts and screw in the guide bar about 40 mm.
- Remove the front bumper bracket lower retaining bolts on both sides.
| | -
Pull the lock panel to the front as far as possible. | | -
Remove the windshield washer reservoir upper retaining screw. | | -
Remove the windshield washer reservoir upper retaining nut. | | -
Remove the windshield washer reservoir lower retaining nut. | | -
Disconnect the generator wiring harness. | | -
Remove the windshield washer reservoir. | Installation | -
To install, reverse the removal procedure. | | |