ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Fuel Charging Wiring Harness > < Fuel Injectors

Ikon 1999 (01.2000-)

Fuel Charging and Controls - 1.3L Endura-E (HCS) - Fuel Pressure Regulator Ikon 1999 (01/2000-)
Removal and Installation

Removal

WARNING:
WARNING:Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and may ignite. Failure to follow these instructions may result in personal injury.
  1. Disconnect the battery ground cable. For additional information, refer to Section  414-01 Battery, Mounting and Cables.
  1. Release the fuel system pressure. For additional information, refer to Section  310-00 Fuel System - General Information.

  1. Remove the air cleaner outlet pipe.

  1. Remove the fuel pressure regulator retaining clip.
    1. Disconnect the vacuum line from the fuel pressure regulator.
    1. Remove the fuel pressure regulator retaining clip.

  1. Remove the fuel pressure regulator.

Installation
  1. NOTE:
    NOTE:Using a suitable engine oil, lubricate the O-ring seals before installing.
    NOTE:
    NOTE:Install new fuel pressure regulator O-ring seals.
    To install, reverse the removal procedure.

Fuel Charging Wiring Harness > < Fuel Injectors