| Disassembly and Assembly of Subassemblies | | -
When a new torque converter is installed the following actions must be carried out. - All coolers (in-tank and auxiliary) must be thoroughly cleaned by back and forward flushing.
For additional information, refer to Transmission Fluid Cooler in this section.
- If the transmission cooling system fails the flow test, new coolers or lines must be installed. If new cooler lines are to be installed refer to Transmission Cooling.
For additional information, refer to Transmission Fluid Cooler Tubes in this section.
If new coolers are to be installed, use only factory approved service parts and refer to Engine Cooling. For additional information, refer to Section 303-03 Engine Cooling. | | | -
If a new torque converter is not being installed, the following must be carried out.: - Carry out transmission cooler flow test as outlined in this section. If the transmission cooling system fails the flow test, new coolers or lines must be installed. If new cooler lines are to be installed, refer to Transmission Cooling. For additional information, refer to Section 307-02A Transmission/Transaxle Cooling / 307-02B Transmission/Transaxle Cooling. If new coolers are to be installed, use only factory approved service parts and refer to Engine Cooling. For additional information, refer to Section 303-03 Engine Cooling.
| | | -
Carry out all torque converter checks listed in this section. | | | -
NOTE:If leaks or damage is detected during inspection, a new torque converter should be installed. Check seal contact surface on the impeller hub of torque converter for excessive wear or scoring. | | | -
Inspect the torque converter studs for damage. | |
/Description and Operation/Diagnosis and Testing/General Procedures/In-vehicle Repair/Removal/Disassembly/Disassembly and Assembly of Subassemblies//img/GD3514A.jpg)
