Ford Workshop Service and Repair Manuals

Alignment Gauge, TR Sensor

307-351 (17-090)

1. Disconnect the battery ground cable.
   For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
   

2. Move the selector lever to "N" NEUTRAL position.

3. Remove the battery.

4. Remove the battery tray.
   • Remove the clips.

5. Remove the transmission range (TR) sensor.
   1. Disconnect the TR electrical connector.
   2. Remove the retaining bolts.

1. 

   NOTE:Make sure the transaxle is in the "N" (NEUTRAL) position.
   Position the TR sensor and loosely install the bolts.

2. 

   NOTE:As necessary, move the manual control lever to "N" (NEUTRAL) position for TR sensor adjustment.
   Rotate the manual valve detent lever assembly to the "N" (NEUTRAL) position.
   1. Low 1 position.
   2. Low 2 position.
   3. "D" (DRIVE) position.
   4. "N" (NEUTRAL) position.
   5. "R" (REVERSE) position.
   6. "P" (PARK) position.

3. Install the TR sensor.
   1. Using the special tool, align the TR sensor.
   2. Tighten the retaining bolts and remove the special tool.
   3. Connect the electrical connector.

4. Install the battery tray.
   • Install the clips.

5. Install the battery.

6. Connect the battery ground cable.
   For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
   

7. Check the correct operation. With parking brake applied the engine should start only in "P" (PARK) or "N" (NEUTRAL) positions. Reversing lamps should illuminate only when "R" (REVERSE) is selected.

8. Initialize the door window motors.
   For additional information, refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).