ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Engine Front Cover > < Crankshaft Front Seal

Transit 2006.5 (04.2006-)

Engine - 2.4L Duratorq-TDCi (Puma) Diesel - Valve Cover Transit 2006.5 (04/2006-)
In-vehicle Repair

General Equipment
Pneumatic Vacuum Gun

Removal

WARNING:
WARNING:Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and may ignite. Failure to follow these instructions may result in personal injury.
CAUTION:
CAUTION:Diesel fuel injection equipment is manufactured to very precise tolerances and fine clearances. It is therefore essential that absolute cleanliness is observed when working with these components. Always install blanking plugs to any open orifices or lines.
  1. Remove the fuel injectors.
    For additional information, refer to: Fuel Injectors (303-04D Fuel Charging and Controls - 3.2L Duratorq-TDCi (Puma) Diesel, Removal and Installation).

  1. Disconnect the cylinder head temperature (CHT) sensor electrical connector.

  1. Remove the valve cover.
    1. Discard the studs.

Installation

  1. NOTE:
    NOTE:Install a new valve cover gasket as necessary.
    To install reverse the removal procedure.

Engine Front Cover > < Crankshaft Front Seal