S2000 L4-2.2L (2004)
5. Align the hole in the flywheel with the crankshaft dowel pin, and install the flywheel. Install the washer and mounting bolts, finger-tight.
6. Install the special tool, then torque the flywheel mounting bolts in a crisscross pattern in several steps.
Release Bearing Inspection
Check the play of the release bearing by spinning it with your hand, if there is excessive play, replace the release bearing with a new one.
NOTE: The release bearing is packed with grease. Do not wash it in solvent.
Clutch Disc and Pressure Plate Installation
1. Apply a thin, uniform coat of super high temp urea grease (P/N 08798-9002) to the splines (A) of the clutch disc (B). Slide the clutch disc onto the
mainshaft, and remove extra overflow grease.