Hombre S Regular Cab 4WD V6-4.3L (1999)
3. Remove the brake pads from the caliper bracket.
4. Inspect the caliper bracket boots for the following conditions:
-
Cuts
-
Tears
-
Deterioration
Replace the bracket boots if damage exists.
5. Inspect the piston boot for the following conditions:
-
Cuts
-
Tears
-
Deterioration
Replace the piston boot if damage exists.
6. Inspect the caliper bolts for corrosion or damage. If corrosion exists, use new components (including bushings) when installing the caliper. Do
not attempt to polish away the corrosion.
Installation Procedure
Important: Before installing new brake pads, wipe the outside surface of the caliper boot clean. Use denatured alcohol.
Caution: Do not move the vehicle until a firm brake pedal is obtained. Failure to obtain a firm pedal before moving vehicle may result in
personal injury.
1. Bottom the piston into the caliper bore.
Use a C-clamp with a metal plate or a wooden block across the face of the piston. Do not damage the piston or the caliper boot.
2. The wear sensor is on the outside pad. Position the sensor at the trailing edge (downward) of the pad during forward wheel rotation.
