Hombre S Regular Cab 4WD V6-4.3L (1999)
13. Remove the spark plug for number one cylinder.
14. Rotate the crankshaft until number one cylinder is in the compression stroke.
15. Align the two reference marks on the crankshaft balancer (1) and (4) with the two alignment marks (2) and (3) on the front cover.
16. Install the spark plug.
17. Install the distributor.
18. Position the engine wiring harness.
19. Install the engine wiring harness in the retainers.
20. Install the following electrical connectors:
-
The fuel meter body assembly
-
The EVAP canister purge solenoid valve
-
The idle air control (IAC) motor
-
The throttle position (TP) sensor
-
The A/C compressor high pressure switch, if equipped.
-
The A/C compressor clutch switch, if equipped.
-
The exhaust gas recirculation (EGR) valve
-
The engine coolant temperature (ECT) sensor
-
The ignition coil
-
The ignition control module (ICM)
21. Install the accelerator cable and cruise control bracket to the throttle body.
Tighten the accelerator cable and cruise control bracket nuts to 9 N.m (80 lb in).
