Hombre S Regular Cab 4WD V6-4.3L (1999)
5. Turn the steering wheel 180 degrees to gain access to the remaining access holes.
6. Insert a screwdriver into each access hole and push the leaf spring to release the pin that retains the inflator module.
7. Tilt the top of the inflator module rearward to gain access to the SRS wiring.
8. Disconnect the SRS lead wire from the clip on the inflator module.
9. Disconnect the SRS lead wire from the clip on the steering wheel.
10. Disconnect the connector position assurance (CPA) retainer.
11. Disconnect the electrical connector.
12. Remove the inflator module from the vehicle.
CAUTION: When you are carrying an undeployed inflator module:
-
Do not carry the inflator module by the wires or connector on the inflator module.
-
Make sure the bag opening points away from you.
When you are storing an undeployed inflator module, make sure the bag opening points away from the surface on which the inflator rests. When
you are storing a steering column, do not rest the column with the bag opening facing down and the column vertical. Provide free space for the air
bag to expand in case of an accidental deployment. Otherwise, personal injury may result.
Installation Procedure
