Hombre S Regular Cab 4WD V6-4.3L (1999)
10. Remove the pinion flange using the J 8614-01. Use a container in order to retrieve the lubricant.
Installation Procedure
Tools Required
J 8614-01 Companion Flange Holder
1. Apply a seal lubricant to the outside of the pinion flange.
Important: Do not hammer the pinion flange onto the pinion stem.
2. Install the pinion flange.
3. Install the washer and a new nut.
Tighten
Tighten the nut on the pinion stem as close to the original marks as possible without turning the nut past the mark. Use the reference
mark and the thread count as a reference. Tighten the nut slightly. Turn the pinion flange several times after each tightening in order
to set the rollers.
