Hombre XS Space Cab L4-2.2L CPC (1997)
4. Hold the J 41552 puller in place and Tighten the puller screw against the puller guide to remove the pulley rotor and bearing assembly.
5. To prevent damage to the pulley rotor during bearing removal the rotor hub must be properly supported.
Remove the forcing screw from J 41552 puller and, with the puller tangs still engaged in the rotor slots, invert the assembly onto a solid flat
surface or blocks.
6. Drive the bearing out of the rotor hub with rotor bearing remover J 9398-A and J 29886 universal handle.
NOTE: It is not necessary to remove the staking in front of the bearing to remove the bearing, however, it will be necessary to file away the old
stake metal for proper clearance for the new bearing to be installed into the rotor bore or the bearing may be damaged.
Install or Connect
1. Place the pulley rotor on the J 21352-A support block to fully support the rotor hub during bearing installation.
NOTE: DO NOT support the rotor by resting the pulley rim on a flat surface during the bearing installation or the rotor face will be bent
2. Align the new bearing squarely with the hub bore and using puller and bearing installer J 9481-A with universal handle J 29886, drive the bearing
fully into the hub. The installer will apply force to the outer race of the bearing, if used as shown.
