Hombre XS Space Cab L4-2.2L CPC (1997)
3. Place bearing staking guide J 33019-1 and bearing staking pin J 33019-2 in the hub bore. Shift the rotor and bearing assembly on the J 21352-A
support block to give full support of the hub under the staking pin location. A heavy-duty rubber band may be used to hold the stake pin in the
guide, and the stake pin should be properly positioned in the guide after each impact on the pin.
4. Using care to prevent personal injury, strike the staking pin with a hammer until a metal stake, similar to the original, is formed down to but not
touching the bearing.
Noisy bearing operation and reduced bearing life may result if outer bearing race is deformed while staking, The stake metal should not contact the
outer race of the bearing. Stake three places 120 degrees apart.
5. With the compressor mounted to the J 33026 holding fixture, position the rotor and bearing assembly on the front head.
6. Position the J 33017 pulley, rotor and bearing installer and J 33023-A puller pilot directly over the inner race of the bearing.
7. Position puller crossbar J 8433-1 on the puller pilot J 33023-A and assemble the two J 3302-2 through bolts and washers through the puller bar
