Hombre XS Space Cab L4-2.2L CPC (1997)
INSTALLATION
1. Install the new ball joint into the lower control arm by pressing in the ball joint using the Special Service Tool (SST). The ball joint will bottom on
the control arm then locate the grease fitting facing inboard.
2. Insert the ball joint stud into the steering knuckle.
3. Install the stud nut onto the stud and tighten the nut to 113 Nm (84 ft. lbs.) and align the slot in the stud nut with the hole in the stud by tightening.
4. insert the new cotter pin into the stud.
5. Install the grease fittings then lubricate the ball joint until grease appears at the seal.
6. Install the brake caliper.
7. Install the tire and wheel assembly then lower the vehicle.
NOTE: Check the front end alignment.