Rodeo LS 4WD V6-3.2L (1998)
-
Remove the two recessed mounting screws fastening the slide to the lid. (Figure 3)
7.
Align and install the new lid to the slide. (Figure 4 & 5)
-
Stamped near one of the recessed mounting screw access hole on the slide is a small 1. This end should be mounted to the opposite end of the
cup holder lid strike plate.
NOTE
Pay close attention to the correct alignment of the slide and lid. If the two mounting holes are mismatched, the slide will not fit correctly into the
rack.
-
Hand-tighten the two recessed screws fasten the slide to the new lid.