Rodeo LS 4WD V6-3.2L (1998)
3.
Use the new strike plate as a guide to:
(Figure 1)
-
Align the new strike plate to the top edge of the molded recess on the base.
-
Center punch the strike plate screw hole.
4.
Drill a 5/64-inch hole through the center-punched location of the base.
-
Remove any burrs or residual adhesive from the strike plate-mounting surface.
5.
Install the new strike plate using the supplied # 4 x 3/8" screw and flat nut.
-
Attach the strike plate with the counter-bored portion facing outwards.
-
Do not allow the.flat nut to be fixed at an angle. Any protruding portion of the flat nut will interfere during opening of the cup holder.
-
Do not over-tighten the screw.
6.
Remove and discard the cup holder lid.
-
Remove the two screws holding the ribbon-shaped retaining plate to the slide. (Figure 2)
-
Remove the ribbon-shaped retaining plate.