Rodeo S 2WD L4-2.2L (1999)
5.
Remove the ashtray/rear beverage holder assembly from the rear console assembly (Figure 3).
6.
Open the beverage holder lid and move the beverage holder swing arm to a position halfway between open and closed.
7.
Re-install any loose detent clips securely in place (Figure 4).
8.
If a detent clip is missing install a new one (part number: 8-97212-275-0).
Note:
Check to be sure both detent clips are securely installed prior to reassembly of the console.
9.
Install the ashtray/beverage holder assembly to the rear of the console.
10.
Reinstall the rear console assembly (Note: On A/T models be sure to reconnect the Power Mode/Winter mode switch).
11.
Open and close the rear beverage holder swing arm several times to be the detents hold.