Rodeo S 2WD L4-2.2L (1999)
10. Measure the plastigage width and determine the oil clearance. If the oil clearance exceeds the specified limit, replace the main bearings as a set
and/or replace the crankshaft.
Standard: 0.015 mm - 0.04 mm (0.0007 inch - 0.O016 inch)
Limit: 0.12 mm (0.0047 inch)
11. Clean the plastigage from the bearings and the crankshaft.
Remove the crankshaft and the bearings.
Crankshaft (12) Inspection
Inspect the surface of the crankshaft journal and crank pins for excessive wear and damage. Inspect the oil seal fitting surfaces for excessive wear and
damage. Inspect the oil ports for obstructions.
INSPECTION AND REPAIR
1. Carefully set the crankshaft. Slowly rotate the crankshaft and measure the runout. If the crankshaft runout exceeds the specified limit, the
crankshaft must be replaced.
Runout: 0.03 mm (0.0012 inch)
2. Measure the diameter and the uneven wear of main journal and crank pin. If the crankshaft wear exceeds the specified limit, crankshaft must be
replaced.