Rodeo S 2WD L4-2.2L (1999)
^
A 15-centimeter steel pocket ruler.
^
Kite string. About three feet in length.
^
Line level
^
"Crossmark" on a nut with magnet
NOTE:
If the above items are not available, use the procedure for ride height adjustment in the appropriate workshop manual.
34.
Glue the magnet to the outside of the crosshair nut (P/N 8-97141-154-0). (Figure 20)
35.
Paint a "crossmark" on the center of the nut/magnet for reference. (Figure 20)
36.
Place the vehicle on level ground or the Alignment Rack.
37.
Make certain the vehicle has the correct tire pressure according to the vehicle's specified tire pressure located on the driver side B-pillar or the
owner's manual
38.
Install the "crossmarked" nut onto the Lower Control Arm Bolt spinning the bolt on at least three turns. (Figure 21)
39.
Align the "crossmark" in a perfect horizontal position.
