Rodeo S 2WD L4-2.2L (1999)
Virginia, Wisconsin, Kentucky and the District of Columbia.
PARTS INFORMATION
An initial supply of parts likely to be necessary for most vehicles has been sent to each Service Facility. This initial shipment is calculated to provide the
Facility with the minimum parts necessary to begin repairs and is based on vehicles assigned and the geographical location of the facility. Subsequent
parts required to complete this campaign are to be obtained from American lsuzu Parts Distribution Network (AIPDN). Please refer to your "involved
vehicles listing before ordering parts. Normal orders should be placed on a Daily Order. In an emergency situation parts should be ordered on a VOR
(Vehicle Off Road) Order.
Required Tools
Below are the tools that will be required to complete all procedures in this bulletin. Tools marked with an asterisk "?" will be provided by Isuzu. All
others may be substituted with equivalents.
IMPORTANT NOTICE
Tools required for all repairs:
^
Wire Brush
^
Scraper
^
12-16oz. Hammer
^
3/16 X 9 Flat Punch
^
Air blow gun Tools required for Conditions Three and Four repairs3
^
Reciprocating saw and blades(14TPI or greater)
^
Ratcheting Straps (2)
^
3/8 and 1/2" drill motor
^
1/4 Drill Bit
^
9 inch "C" clamps (2)
^
*1/4 drill bit guide or equivalent (optional method SnapOn E1521 with 3/16" drill bit)
^
*33/64 Silver/Deming Drill HSS 118 Degree (Grainger P/N 2BT43)
^
*POP Nut Installer w/regulator
^
4"x4"x7 wood blocks (2) and 4"x4"x10.25" wood blocks (2)
