Rodeo S 2WD L4-2.2L (1999)
13.
Turn the ignition switch to LOCK (see figure 7).
^
If you cannot turn the switch to LOCK because the cable slider is blocking the white plastic interlock pin, go to step 14.
^
If you cannot turn the switch to LOCK, and the cable slider is clear of the white plastic interlock pin, troubleshoot the lock cylinder assembly.
14.
Move the cable slider so it clears the interlock pin, and then turn the ignition switch to LOCK (figure 8).
15.
Pry out the shift lock cable adjuster clip and snap it back, into place. The raised "T" on the side of the clip must face up (figure 9).
16.
Turn the ignition switch to ACC and push the cable slider towards the cable until it stops. Turn the ignition switch to LOCK.
^
If you can turn the switch to LOCK, the shift lock cable is adjusted correctly. Press firmly on the shift lever push-button, pull down the shift
lever to make sure the lever is locked into the P position. Go to step 19.
^
If you cannot turn the switch to LOCK, or it still feels "Notchy" when you turn it, more adjusting is required. Go to step 17.
