Trooper LS V6-3.5L (1998)
See TSB SB94-01-003 12-94
1.
Install cylinder head cover.
-
Clean the sealing surface of cylinder head and cylinder head cover to remove oil and sealing materials completely.
-
Apply sealant (TB-1207B or equivalent) of bead diameter 2 - 3 mm at eight place of arched area of camshaft bracket on front and rear sides.
-
The cylinder head cover must be installed within 5 minutes after sealant application to prevent premature hardening of sealant.
-
Tighten bolts to the specified torque.
Torque: 9 Nm (80 inch lbs.)
2. Install ignition coil assemblies and tighten the fixing bolts to the specified torque.
Torque: 4 Nm (35.4 inch lbs.)
3. Install timing belt covers from left bank side to right bank side, and tighten the fixing bolts and nut to the specified torque.
Torque: 19 Nm (14 ft. lbs.)
4. Install crankshaft pulley and tighten the fixing bolt using J-8614-01 crankshaft holder to the specified torque.
Torque: 167 Nm (123 ft. lbs.)
5. Install auto tensioner assembly and tighten the fixing bolts to the specified torque.
Torque:
Shorter Bolt: 20 Nm (14.8 ft. lbs.)
Longer Bolt: 39 Nm (28.8 ft. lbs.)
6. Install idle pulley assembly and tighten the fixing bolt to the specified torque.
Torque: 52 Nm (38.4 ft. lbs.)
7. Install fan pulley and bracket assembly and tighten the fixing bolts and nut to the specified torque.
Torque: 22 Nm (16.2 ft. lbs.)
8. Install power steering oil pump pulley and tighten the fixing bolt to the specified torque.