S-Type (X200) V8-4.2L (2005)
5. Remove the exhaust manifold.
^
Remove and discard the retaining bolts and heat shield/gasket.
Installation
All vehicles
1. CAUTION: Make sure that the exhaust manifold and heat shield/gasket is correctly aligned to cylinder head.
Install the exhaust manifold.
^
Loosely install new retaining bolts and a new heat shield/gasket.
2. Tighten the exhaust manifold retaining bolts to 25 Nm.
3. NOTE: Engine shown removed for clarity.
Install the right-hand exhaust manifold heat shield/gasket retaining bolt.
^
Tighten to 50 Nm.
4. NOTE: Engine shown removed for clarity.