Sephia Sedan L4-16L SOHC 16V Air Bag Systems Component Information
If the module is deployed and there is one (single, 2-pin) connector, the airbag cannot deploy a second time, and it is inert/deployed/expended.
*NOTICE
DO NOT ATTEMPT TO DEPLOY ANY AIRBAG WHILE STILL INSTALLED IN A VEHICLE. SIGNIFICANT DAMAGE TO THE VEHICLE
WILL RESULT.
^
Next, connect the adapter between the A/B and the deployment tool harness connector.
^
Place the deployment tool at least thirty feet (10 meters) away
from the airbag.
^
Connect a 12 volt battery to the tool.
Once an intact airbag has been removed from a vehicle, or has been found defective or damaged during transit, storage or service, it should be deployed
as shown below, after the proper SST (Special Service Tool) adapters have been selected:
DEPLOYING AIRBAGS
Deployment tool K95U-6000-BDY is required for any deployment, along with one or more of the adapters listed under "SRS Deployment Adapter Cross
Reference" in the Tool & Equipment section of KGIS.
(Current Models listed only; consult Service Manual for previous model information)
Before demonstrating any airbag-, side airbag or pre-tensioner deployments, the manager in charge must give approval and ensure that safety instructions
are provided to participants and audience.
