Sephia Sedan L4-1.6L SOHC 16V (1993)
^
Confirm that the deployment tool is functioning properly, harness and adapters are operational and not damaged.
^
For curtain airbags: using scissors or pliers, cut the attaching straps and remove any mounting brackets, etc. from the bag to be deployed, to prevent
them from separating during deployment.
^
Position the airbag face up, outdoors on flat ground at least thirty
feet (10 meters) from any obstacles or people.
^
From KGIS Tool & Equipment Section, select the proper vehicle model table, then select the correct SST adapter.
WARNING
ENSURE DEPLOYMENT TOOL HARNESS CONNECTION IS NOT CONNECTED TO A BATTERY OR POWER SOURCE.
FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN SEVERE PERSONAL INJURY OR DEATH.
^
Next, connect the adapter between the A/B and the deployment tool harness connector.
^
Place the deployment tool at least thirty feet (10 meters) away
from the airbag.
^
Connect a 12 volt battery to the tool.
WARNING
THE OUT-OF-VEHICLE DEPLOYMENT PROCEDURE SHOULD BE PERFORMED IN AN OPEN AREA AWAY FROM OTHER
PERSONNEL. VERIFY THAT THERE IS NO LOOSE DEBRIS AROUND THE AIR BAG ASSEMBLY. ENSURE NO FLAMMABLE
LIQUIDS ARE PRESENT. ALL PERSONNEL SHOULD BE BEHIND PROTECTIVE COVER (I.E., WALL, VEHICLE, ETC.) TO SHIELD
THEIR BODIES FROM ANY POTENTIAL PROJECTILES. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN SEVERE
PERSONAL INJURY OR DEATH.
Wear gloves and safety glasses.
^
Push the tool's deployment switches. The airbag should deploy (deployment is both highly audible and visible: a loud noise and rapid inflation of the
bag, followed by slow deflation).
Allow airbag components to cool down before handling.
WARNING
AIR BAG MODULE COMPONENTS ARE VERY HOT AFTER DEPLOYMENT. UNITS SHOULD BE DEPLOYED IN AN OPEN AREA TO
PREVENT ACCIDENTAL FIRES. ALLOW INFLATORS AND MODULES TO THOROUGHLY COOL AT LEAST 20 MINUTES AFTER
DEPLOYMENT. COOLING AIR BAG MODULES SHOULD BE CONTINUOUSLY MONITORED TO ENSURE THE HEAT GENERATED
DOES NOT CREATE A FIRE WITH SPILLED LIQUIDS OR OTHER DEBRIS. FAILURE TO ALLOW DEPLOYED UNIT TO PROPER COOL
COULD RESULT IN BURNS OR FIRES OR PERSONAL INJURY.
