FLYWHEEL SIDE DETONATION SENSOR - R.R.

Operation 5510C46 · COIL, CONTROL UNIT, SENSORS

3.0 V6, 3.2 V6

Removing

- Position the vehicle on a lift.

- Open the boot, remove the cover on the left hand side and disconnect the negative battery lead.

See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.

See in Op. 1072B42 INTAKE MANIFOLDS (all) - R.R. and Replace gasket

See in Op. 4450B02 Left FRONT WHEEL (one) - R.R.

See in Op. 7055B42 FRONT WHEEL ARCH LINER (one), left or right - R.R.

See in Op. 1048A28 vacuum air circuit resonator pipe - r+r

See in Op. 1048A35 HOSE FROM FLOW METER TO RESONATOR - R.R.

See in Op. 1048A11 COMPLETE AIR FILTER -R.R.

See in Op. 1088C36 THERMOSTAT MOUNTING - R.R.

See in Op. 1088D24 RIGID PIPE for coolant inlet to water pump - R and R

1. Undo the bolt (1a) and remove the flywheel side detonation sensor (1b)

Refitting

- Fit the flywheel side detonation sensor and secure it tightening the bolt to the recommended toqrue.

See in Op. 1088D24 RIGID PIPE for coolant inlet to water pump - R and R

See in Op. 1088C36 THERMOSTAT MOUNTING - R.R.

See in Op. 1048A11 COMPLETE AIR FILTER -R.R.

See in Op. 1048A35 HOSE FROM FLOW METER TO RESONATOR - R.R.

See in Op. 1048A28 vacuum air circuit resonator pipe - r+r

See in Op. 7055B42 FRONT WHEEL ARCH LINER (one), left or right - R.R.

See in Op. 4450B02 Left FRONT WHEEL (one) - R.R.

See in Op. 1072B42 INTAKE MANIFOLDS (all) - R.R. and Replace gasket

See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.

- Connect the negative battery lead, then close the boot.

- Remove the vehicle from the lift.