RPM SENSOR - R.R.

Operation 5510C36 · COIL, CONTROL UNIT, SENSORS

2.0 TB, 2.4 20V

Removing

- Position the vehicle on the lift.

- Make sure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.

See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.

1. Disconnect the rpm sensor electrical connector.

- Raise the vehicle on the lift.

See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.

See in Op. 1076B68 EXHAUST PIPE FLEXIBLE SECTION - R.R.

1. Undo the bolt (1a), release the electrical wiring from the retaining bands on the modular intake chamber and remove the rpm sensor (1b).

Refitting

- Position the rpm sensor in its housing and secure it using the bolt.

- Secure the electrical wiring to the modular intake chamber using the retaining bands.

See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.

- Lower the vehicle on the lift.

See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.

- Connect the rpm sensor electrical connector.

- Connect the negative battery terminal.

- Remove the vehicle from the lift.