Engine oil collection MANIFOLD - R.R.

Operation 1080D35 · Crankcase vapour/gas recirculation system

1.3 JTD

Removing

Position the vehicle on the ramp.

Make sure that the ignition is OFF, then loosen the bolt and disconnect the battery negative (-) terminal.

Proceed with removal - 4450B04 right front wheel r r.

Proceed with removal - 7055B66 Engine compartment DUST SHIELD protection in right front wheel arch - R.R..

Proceed with removal - 7055B91 Right front WHEEL ARCH LINER - R.R..

Proceed with removal - 1092G10 single engine belt r r.

Proceed with removal - 5530A10 alternator - r+r.

Proceed with removal - 5530A40 alternator brackets/mount/spacer - r r.

Disconnect the electrical connections from the starter motor and move them aside.

1. Loosen the band and disconnect the engine oil recovery pipe, engine oil recovery manifold side.

2. Undo the bolts (2a) and remove the engine oil recovery manifold (2b) complete with gaskets (2c).

Refitting

Refit in its seating the engine oil recovery manifold complete with gaskets and secure it with the bolts.

Connect the engine oil recovery pipe, engine oil recovery manifold side, and tighten the band.

Connect the electrical connections to the starter motor.

Proceed with refitting - 5530A40 alternator brackets/mount/spacer - r r.

Proceed with refitting - 5530A10 alternator - r+r.

Proceed with refitting - 1092G10 single engine belt r r.

Proceed with refitting - 7055B91 Right front WHEEL ARCH LINER - R.R..

Proceed with refitting - 7055B66 Engine compartment DUST SHIELD protection in right front wheel arch - R.R..

Proceed with refitting - 4450B04 right front wheel r r.

Connect the negative (-) battery terminal.

Remove the vehicle from the ramp.