300Tdi Discovery
V8i
1
REPAIR
EXPANSION TANK
Service repair no - 26.15.01
Remove
WARNING: Do not remove expansion tank
filler cap when engine is hot. The cooling
system is pressurised and personal
scalding could result.
1. Remove expansion tank filler cap by first turning
it slowly anti-clockwise, pause to allow pressure
to escape. Continue turning in same direction
and lift off.
2. Disconnect two hoses from bottom of expansion
tank, allowing coolant to drain into a suitable
container.
3. Remove three fixing bolts, remove expansion
tank.
Refit
4. Reverse removal procedure.
5. Replenish cooling system.
6. Check for leaks around all hose connections.
VISCOUS COUPLING, FAN BLADES, PULLEY AND
COWL
Service repair no - 26.25.19 - Viscous coupling
and fan assembly
Service repair no - 26.25.03 - Water pump pulley
Service repair no - 26.25.05 - Fan blades
Special tools:
LRT-12-093
LRT-12-094 - Viscous coupling removal
Remove
1. Disconnect battery negative lead.
NOTE: 4.0 V8 only:
Release coolant hose from cooling fan upper
cowl.
2. Release 2 clips securing cooling fan upper cowl.
Remove cowl.