300Tdi Discovery
76
CHASSIS AND BODY
52
REPAIR
24. Ensure body flanges and surfaces covered by
the finishers are clean.
25. Shake the primer container for at least 30
seconds.
26. Using a cotton bud, apply Glass Primer (green
cap) to inside face of glass, 20mm (13/16 in)
strip around inside of finishers and 30mm (1 1/8
in) wide along bottom edge. This must be touch
dry before applying adhesive.
27. Remove protective coverings and tape.
28. Pierce top and pre-cut nozzle to sealer cartridge,
remove lid and shake out crystals and install
cartridge in applicator gun.
29. Apply a continuous bead of adhesive sealant
around the glass as shown. Vertical edge of
sealer to abut finishers and to be 8mm (5/16 in)
from bottom edge of glass.
30. Remove protective covering (RED) from side
finisher sealing strip.