Freelander Service Procedures
ENGINE - K SERIES KV6
12-3-22 REPAIRS
5. Remove bolt securing multiplug bracket which
also retains front HO2S multiplug, move
bracket and multiplug aside.
6. Withdraw multiplug lock and disconnect
multiplug from each plug top coil.
7. Remove bolt securing each plug top coil to
camshaft cover and remove 3 plug top coils.
8. Noting location of earth lead and using
sequence shown, progressively loosen and
remove 14 bolts securing camshaft cover.
9. Remove camshaft cover and discard gasket.
Refit
1. Clean mating surfaces of camshaft cover and
carrier.
2. Clean inside of camshaft cover. If necessary,
wash oil separator elements in solvent and
blow dry.
3. Position new gasket to camshaft carrier with
arrows on gasket pointing towards inlet
manifold.
4. Position camshaft cover, align earth lead and fit
and tighten bolts progressively in sequence
shown to 9 Nm (7 lbf.ft).
5. Fit plug top coils, fit bolts and tighten to 5 Nm
(3.7 lbf.ft).
6. Connect and secure multiplugs to plug top
coils.
7. Fit coil harness clip, fit acoustic cover retainer
and tighten to 3 Nm (2.2 lbf.ft).
8. Position multiplug bracket to camshaft cover, fit
and tighten bolt to 9 Nm (7 lbf.ft).
9. Secure male end of CMP sensor multiplug to
bracket and connect multiplug.
10. Connect breather hoses to LH camshaft cover.
11. Check engine oil level, top-up if necessary.
12. Fit the engine acoustic cover.
