Freelander Service Procedures
ENGINE - K SERIES KV6
REPAIRS 12-3-67
Camshaft timing belt cover - LH front
$% 12.65.41
Remove
1. Disconnect battery earth lead.
2. Remove ancillary drive belt.
REPAIRS, Ancillary drive belt - KV6.
3. Remove 3 Torx screws securing PAS pump
pulley, and remove pulley.
4. Remove Torx screw securing idler pulley to
front mounting plate and remove pulley.
5. Remove bolt securing dipstick tube to cylinder
block.
6. Remove 3 bolts securing camshaft timing belt
LH front cover and remove cover.
Refit
1. Clean LH front timing belt cover.
2. Position LH front timing belt cover, fit and
tighten bolts to 4 Nm (3 lbf.ft).
3. Position dipstick tube bracket to cylinder block
and tighten bolt to 9 Nm (7 lbf.ft).
4. Clean idler pulley, position pulley to engine
front mounting plate and tighten Torx bolt to 45
Nm (33 lbf.ft).
5. Position PAS pump pulley, fit and tighten Torx
screws to 9 Nm (7 lbf.ft).
6. Fit ancillary drive belt
REPAIRS, Ancillary drive belt - KV6.
7. Connect battery earth lead.
M12 6672