Freelander Service Procedures
PANEL REPAIRS
REPAIRS 77-2-41
Refit
1. Driver's side: Fit passenger compartment fuse
box.
2. Fit insulation pads to engine bulkhead.
3. Fit front door aperture seal.
4. Position front carpet and fit treadplate to front
door aperture.
5. Fit windscreen.
6. Fit headlining.
7. Fit duct of outboard face level ventilator.
8. Fit fascia.
9. Fit front seat.
10. Fit front door.
- front - remove for access & refit.
11. Fit front wing.
12. Fit front wheel arch liner.
13. Fit road wheel(s) and tighten nuts to 115 Nm
(85 lbf.ft).
14. Connect all ECUs.
15. Connect alternator.
16. Connect battery earth lead.
'A' post - 5 door
In this procedure, the front outer body side panel is
replaced in conjunction with the inner 'A' post and the
'A' post reinforcements.
Remove
1. Disconnect battery earth lead.
2. Disconnect alternator.
3. Disconnect all ECUs.
4. Remove road wheel(s).
5. Remove front wheel arch liner.
6. Remove front wing.
7. Remove front door.
- front - remove for access & refit.
8. Remove front seat.
9. Remove fascia.
10. Remove duct of outboard face level ventilator.
11. Remove headlining.
12. Remove windscreen.
13. Remove treadplate from front door aperture.
Release front carpet and position aside.
14. Remove front door aperture seal.
15. Remove engine bulkhead insulation.
16. Driver's side: Remove passenger
compartment fuse box.