Freelander Service Procedures
PANEL REPAIRS
77-2-56 REPAIRS
Refit
1. LH side: Fit tail door striker.
2. RH side: Fit fuel tank.
PETROL, REPAIRS, Tank - Non NAS.
3. RH side: Fit fuel filler neck.
4. RH side: Fit tail door.
assembly - remove for access & refit.
5. Secure vehicle harness to 'E' post.
6. Fit loadspace carpet.
REPAIRS, Carpet - luggage compartment.
7. Fit rear quarter lower casing.
REPAIRS, Trim casing - rear quarter - lower
- 3 door.
8. Fit tail door aperture seal.
9. Fit soft/hard top.
10. Fit tail lamp.
11. Fit rear wheel arch liner.
12. Fit rear bumper valance.
Bumper valance - rear - up to 04MY.
13. Fit road wheel(s) and tighten nuts to 115 Nm
(85 lbf.ft).
14. Connect all ECUs.
15. Connect alternator.
16. Connect battery earth lead.
Inner 'e' post - 5 door
In this procedure, the rear outer body side panel and
the rear body side reinforcement assembly is
replaced in conjunction with the inner 'E' post
assembly.
Remove
1. Disconnect battery earth lead.
2. Disconnect alternator.
3. Disconnect all ECUs.
4. Remove road wheel(s).
5. Remove rear bumper valance.
Bumper valance - rear - up to 04MY.
6. Remove rear wheel arch liner.
7. Remove tail lamp.
8. Remove roof panel finisher.
DOORS, REPAIRS, Finisher - rear
9. Remove tail door glass upper finisher.
10. Remove tail door glass side finisher.
DOORS, REPAIRS, Finisher - rear
11. Remove tail door aperture seal.
12. Remove rear quarter lower casing.
REPAIRS, Trim casing - rear quarter - lower
- 5 door.
13. Remove rear quarter upper casing.
REPAIRS, Trim casing - rear quarter - upper
- 5 door.
14. Remove loadspace carpet.
REPAIRS, Carpet - luggage compartment.
15. Remove rear body side glass.
SCREENS, REPAIRS, Glass - body
16. Release vehicle harness from 'E' post and
position aside.
17. LH side: Remove tail door striker.
18. RH side: Remove tail door.
assembly - remove for access & refit.
19. RH side: Remove fuel filler neck.
20. RH side: Remove fuel tank.