Freelander Service Procedures
REAR SUSPENSION
REPAIRS
64-5
7. Fit hub to damper and tighten bolts to 205 Nm
(151 lbf.ft).
CAUTION: Nuts and bolts must be tightened
with weight of vehicle on suspension.
8. Fit nut, bolt and washers securing transverse
links to hub and tighten nut to 105 Nm (77 lbf.ft).
9. Fit trailing link to hub and tighten nut and bolt to
120 Nm (89 lbf.ft).
NOTE: Ensure that washers are fitted to both
ends of bolts
10. Clean ABS sensor, smear sensor with an anti-
seize grease and fit sensor to hub.
CAUTION: Ensure ABS sensor is fully
located into hub, so that sensor touches
pole wheel teeth.
11. Fit brake pipe to wheel cylinder and tighten
union to 14 Nm (10 lbf.ft).
12. Fit clip securing brakepipe to bracket.
13. Fit and secure handbrake cable to backplate.
14. Fit brake shoes.
BRAKES, REPAIRS, Brake Shoes -
15. Fit new drive shaft nut and tighten to 400 Nm
(295 lbf.ft). Stake nut to shaft.
16. Bleed brakes.
17. Fit road wheel(s) and tighten nuts to 115 Nm
(85 lbf.ft).
18. Remove stands and lower vehicle.
Damper
$% 64.30.02
Remove
1. Raise rear of vehicle.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
2. Remove road wheel.
3. Clamp brake hose to prevent fluid loss.
4. Position absorbent cloth to catch spillage.
5. Loosen brake pipe union to hose and release
union.
CAUTION: Always fit plugs to open
connections to prevent contamination.
6. Remove clip securing brake hose to bracket on
damper. Release brake hose from bracket.
7. Release ABS sensor harness and brake hose
from damper.
8. Release ABS sensor from hub.